Del ozone Spa-Eclipse Bedienungshandbuch PDF herunterladen (Seite 11)

Turn off the electrical power and completely drain the spa. The DEL RIGID

INJECTOR MANIFOLD must be installed in the spa’s return line after all other

equipment (pump, lter and heater). It should be installed as close to the spa

as possible.

Figure 6: Injector Mounting Diagram

Locate an appropriate section of the return line, hold the injector manifold

against the pipe and mark the length. Subtract 2-2/3” from the overall length,

mark this point, and cut out the section. Install the injector manifold with PVC

cement. The injector manifold can be installed in either a vertical or horizontal

position in the return line.

Make sure the water ow arrow on the ball valve is pointed toward the spa.

Locate the plastic hose connector, wrap 3 layers of teon tape on the threads

(do not use thread sealant), and install it hand tight into 1/2” female pipe thread

tting of the DEL Rigid Injector Manifold. Tighten the plastic hose connector

1/2 turn with a wrench. Secure one end of the ozone supply tubing to the barb

end of the plastic hose connector with a supplied gold hose clamp. Locate

the ozone supply check valve and install it into ozone supply tubing by cutting

tubing in two separate places approximately 4’ from the ozonator and insert

the check valve between each cut, securing both ends of the check valve with

gold hose clamps as shown in Figure 7.

Figure 7: Plastic Hose Connector & Check Valve

Gold Hose Clamps

(2 Places)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

Del ozone Spa-Eclipse Bedienungshandbuch Seite 11